Setup and use

Start with one AA

Insert the AA battery, following the polarity markings in the compartment. Enduro runs for up to approximately four years, depending on the battery and use.

To access the device, slide it out of its holder. You can work with it comfortably in your hand while the holder stays attached.

Set the time & date

Hold the adjustment button for two seconds until the display flashes. Use the + and − buttons to change the values, and SET to step through the time and date.

• Set the date correctly so daylight-saving changes work as expected.
• Use the left slider to switch automatic daylight-saving adjustment on or off.
• Use the right slider to choose a 15- or 30-minute parking interval. Check which interval and type of disc are permitted where you park.

Give it a place

Make sure the windscreen is clean, dry and warm before fitting the adhesive holder. Follow the mounting instructions and the requirements where you use the disc.

The supplied guidance places Enduro at the bottom right of the windscreen when viewed from inside the vehicle. Keep the arrival-time display clearly visible from outside, and only use one parking disc.

Slide the device into the holder and check that it is securely in place.

Check, then enjoy

Take a drive and check that Enduro detects both driving and parking. When you stop, confirm that the arrival time is correct before leaving the vehicle. This check is especially useful after short trips.

For a manual parking time, use the + and − buttons. This can be useful for overnight parking, where the local rules allow a start time the following morning.